Draytek Vigor2620 LTE Series User Manual page 205

Always On
Server IP/Host Name
for VPN
IKE Authentication
Method
Digital Signature
(X.509)
IPsec Security Method
User Name
Password
Remote Network IP
Remote Network
Mask
Local Network IP
Local Network Mask
3. After finishing the configuration, please click Next. The confirmation page will be
shown as follows. If there is no problem, you can click one of the radio buttons listed on
the page and click Finish to execute the next action.
Vigor2620 Series User's Guide
to 10 characters.
Check to enable router always keep VPN connection.
Enter the IP address of the server or Enter the host name for
such VPN profile.
IKE Authentication Method usually applies to those are
remote dial-in user or node (LAN to LAN) which uses dynamic
IP address and IPsec-related VPN connections such as L2TP
over IPsec and IPsec tunnel.
Pre-Shared Key- Specify a key for IKE authentication.
Confirm Pre-Shared Key-Confirm the pre-shared key.
Click Digital Signature to invoke this function.
Peer ID – Choose the peer ID selection from the drop down
list.
Local ID – Choose Alternative Subject Name First or Subject
Name First.
Local Certificate – Use the drop down list to choose one of
the certificates for using. You have to configure one
certificate at least previously in Certificate Management >>
Local Certificate. Otherwise, the setting you choose here
will not be effective.
Medium - Authentication Header (AH) means data will be
authenticated, but not be encrypted. By default, this option
is active.
High - Encapsulating Security Payload (ESP) means payload
(data) will be encrypted and authenticated. You may select
encryption algorithm from Data Encryption Standard (DES),
Triple DES (3DES), and AES.
This field is used to authenticate for connection when you
select PPTP or L2TP with or without IPsec policy above.
The length of the user name is limited to 11 characters.
This field is used to authenticate for connection when you
select PPTP or L2TP with or without IPsec policy above.
The length of the password is limited to 11 characters.
Please type one LAN IP address (according to the real
location of the remote host) for building VPN connection.
Please Enter the network mask (according to the real
location of the remote host) for building VPN connection.
Enter the local network IP for TCP / IP configuration.
Enter the local network mask for TCP / IP configuration.
193