Draytek Vigor2620 LTE Series User Manual page 572

E x a m p l
E x a m p
> vpn option 1 idle=250
% Change Log..
% Idle Timeout = 250
> vpn option 1 itype=t,s,l2 peer=192.168.1.54 peerid=mary iname=userca
rrie ipwd=12345678 ivj=on ikey=abcd imeth=h
% Change Log..
% Allowed Dial-In Type : PPTP IPsec L2TP(Must)
% Allow dial from (IP) : 192.168.1.54
% Allow dial from (peer id): mary
% Dial-in Username = usercarrie
% Password : 12345678
% VJ Compression (dial-in) = on
% Pre-share Key (dial-in): abcd
% Dial-in IPsec Security Method: AH
>
T e l n e t C o m m
T e l n e t C o m m
This command allows users to list, add or delete static routes for a certain LAN to LAN VPN
profile.
S y n t a x
S y n t a x
vpn mroute <index> list
560
For example, rnip=4.5.6.7 means the IP address "4.5.6.7" is
used as the Remote Network IP.
<rnmask=>: Enter rnmask=mask address to set the Remote
Network Mask. For example, rnmask=255.255.255.0 means
the mask address "255.255.255.0" is used as the Remote
Network Mask.
<lnip=>: Enter lnip=IP address to set the Local Netowrk IP.
For example, lnip=1.2.3.4 means the IP address "1.2.3.4" is
used as the Local Netowrk IP.
<lnmask=>: Enter lnmask=mask address to set the Local
Network Mask. For example, lnmask=255.255.255.200 means
the mask address "255.255.255.00" is used as the Local
Network Mask.
<rip=>: Enter rip=d, t, r or b to set RIP Direction.
<mode=>: Enter mode=r or mode=n.
<droute=>: Enter droute=off or droute=on for the option of
"Change default route to this VPN tunnel ( Only single WAN
supports this)".
e
l e
a n d : v p n m r o u t e
a n d : v p n m r o u t e
d, Disable
t, TX
r, RX
b, Both
mode=r means to set Route mode for the option of "From
first subnet to remote network, you have to do".
mode=n means to set NAT mode for the option of "From
first subnet to remote network, you have to do".
droute=on means to enable the fuction.
droute=off means to disable the function.
Vigor2620 Series User's Guide