Draytek Vigor2620 LTE Series User Manual page 130

Info
Available settings are explained as follows:
Item
Enable
LAN
Wireless LAN
Subnet
VLAN Tag
Info
The Vigor router supports up to 8 VLANs. Each VLAN can be set up to use one or more of the
Ethernet ports and wireless LAN Service Set Identifiers (SSIDs). Within the grid of VLANs
(horizontal rows) and LAN interfaces (vertical columns),
 all hosts within the same VLAN (horizontal row) are visible to one another
 all hosts connected to the same LAN or WLAN interface (vertical column) are visible to
one another if
- they belong to the same VLAN, or
- they belong to different VLANs, and inter-LAN routing (LAN>>General Setup) between
them is enabled (see below).
118
Settings in this page only applied to LAN port but not WAN port.
Description
Click it to enable VLAN configuration.
P1 – P2– Check the LAN port(s) to group them under the
selected VLAN.
SSID1 – SSID4 – Check the SSID boxes to group them under the
selected VLAN.
Choose one of them to make the selected VLAN mapping to
the specified subnet only. For example, LAN1 is specified for
VLAN0. It means that PCs grouped under VLAN0 can get the
IP address(es) that specified by the subnet.
Enable – Check the box to enable the function of VLAN with
tag.
The router will add specific VLAN number to all packets on
the LAN while sending them out.
Please Enter the tag value and specify the priority for the
packets sending by LAN.
VID – Enter the value as the VLAN ID number. The range is
form 0 to 4095. VIDs must be unique.
Priority – Valid values are from 0 to 7, where 1 has the
lowest priority, followed by 0, and finally from 2 to 7 in
increasing order of priority.
Leave one VLAN untagged at least to prevent from not connecting to Vigor
router due to unexpected error.
Vigor2620 Series User's Guide