Draytek Vigor2620 LTE Series User Manual page 566

<list index> multicastvpn
<pass/block>
<list index> prekey
<on/off>
<list index> assignkey
<Pre_Shared_Key>
<list index>digsig
<on/off>
<list index> ipsec
<Method> <on/off>
<list index> localid
<Local_ID>
E E x x a a m m p p l
> vpn dinset 1
Dial-in profile index 1
Profile Name: ???
Status: Deactive
Mobile OTP: Disabled
Password:
554
Block, when there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, it can block data
transmission of Netbios Naming Packet inside the tunnel.
<list index>: Enter the index number of L2L (LAN to LAN)
profile.
<pass/block>: Enter pass or block.
Pass –Let multicast packets pass through the router.
Block – This is default setting. It can let multicast packets be
blocked by the router.
It means to enable/disable the pre-shared key for IKE
authentication method.
<list index>: Enter the index number of L2L (LAN to LAN)
profile.
<on/off>: Enter on or off.
On, Enable.
Off, Disable.
Assign the pre-shared key.
<list index>: Enter the index number of L2L (LAN to LAN)
profile.
<Pre_Shared_Key>: Enter a string.
Enable /disable the function of Digital Signature (X.509) for
IKE authentication method.
Set the IPsec security medthod for the specified VPN profile.
<list index>: Enter the index number of L2L (LAN to LAN)
profile.
<Method>: Enter 0, 1, 2 or 3.
0, Medium(AH) High(ESP)
1, DES
2, 3DES
3, AES
<on/off>: Enter on or off.
On, Enable.
Off, Disable..
Assign a local ID to be used for Dial-in setting in the
LAN-to-LAN Profile setup.
<list index>: Enter the index number of L2L (LAN to LAN)
profile.
<Local_ID>: Enter a string.
l e e
Vigor2620 Series User's Guide