Draytek Vigor2620 LTE Series User Manual page 106

Connection for this
Channel
Open WAN Interface for
this Channel
PPPoE/PPPoA Client
94
selected and the WAN. The WAN interface of the bridge
connection will be built upon the WAN type selected using
the VLAN tag configured.
Physical Members – Group the physical ports by checking the
corresponding check box(es) for applying the port-based
bridge connection.
Note: LAN port P1 is reserved for NAT use and cannot be
selected for bridging.
Check the box to enable relating function.
WAN Application
Management can be specified for general management

(Web configuration/telnet/TR069). If you choose
Management, the configuration for this VLAN will be
effective for Web configuration/telnet/TR069.
IPTV - The IPTV configuration will allow the WAN

interface to send IGMP packets to IPTV servers.
WAN Connection Detection – Such function allows you to
verify whether network connection is alive or not through
ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection. If you choose Ping Detect as the
detection mode, you have to type required settings for the
following items.

Primary/Secondary Ping IP – If you choose Ping Detect as
detection mode, you have to type Primary or Secondary IP
address in this field for pinging.

Ping Gateway IP – If you choose Ping Detect as detection
mode, you also can enable this setting to use current WAN
gateway IP address for pinging.
With the IP address(es) pinging, Vigor router can check if
the WAN connection is on or off.

TTL (Time to Live) – Set TTL value of PING operation.

Ping Interval – Type the interval for the system to
execute the PING operation.

Ping Retry – Type the number of times that the system is
allowed to execute the PING operation before WAN
disconnection is judged.
Enter your allocated username, password and authentication
parameters according to the information provided by your
ISP.
ISP Name – PPP Service Name. Enter if your ISP requires this
setting; otherwise leave blank.
Username – Name provided by the ISP for PPPoE/PPPoA
authentication. Maximum length is 62 characters.
Password – Password provided by the ISP for PPPoE/PPPoA
authentication. Maximum length is 62 characters.
PPP Authentication –The protocol used for PPP
authentication.

PAP only- Only PAP (Password Authentication Protocol)
is used.

PAP or CHAP- Both PAP and CHAP
(Challenge-Handshake Authentication Protocol) can be
used for PPP authentication. Router negotiates with the
PPTP or L2TP server to determine which protocol to
Vigor2620 Series User's Guide