Draytek Vigor2620 LTE Series User Manual page 570

<idle=> <palive=>
For Dial-Out Settings
<index> <ctype=>
<dialto=> <ltype=>
<oname=> <opwd=>
<pauth=> <ovj=> <okey=>
<ometh=> <sch=>
<ikemode=> <ikeid=>
558
pname=testname).
<ena=>: Enter ena=on or ena=off. In which, on means
Enable, off means disable.
<nnpkt=>: Enter nnpkt=on or nnpkt=off to pass or block the
NetBios Naming Packet. In which, on means pass, off means
block.
<dir=>: Enter dir=b, dir=o or dir=i to determine the call
direction. In which, b means Both, o means Dial-Out and i
means Dial-In.
<idle=>: Enter idle=-1, idle=0 or idle=other value. In which,
-1 means always on for dial-out, 0 means always on for
dial-in. Other numbers (e.g., idle=200, idle=300, idle=500)
mean the router will be idle after the interval (seconds)
configured here.
<palive=>: Enter palive=-1, or palive=IP address for PING to
keep alive. In which, -1 means to disable the function. If an
IP address is specified here, it means to enable PING to the IP
address.
<index>: Enter the index number of L2L (LAN to LAN) profile.
<ctype=>: Enter ctype=t, ctype=s, ctype=l, ctype=l1 or
ctype=l2 to set "Type of Server I am calling".
t, PPTP
s, IPSec.
l, L2TP(IPSec Policy None).
l1, L2TP(IPSec Policy Nice to Have).
l2, L2TP(IPSec Policy Must).
<dialto=>: Enter dialto=IP address or dialto=Host Name for
VPN (such as dialto=draytek.com or dialto=123.45.67.89).
<ltype=>: Enter ltype=0, ltype=1, ltype=2 or ltype=3 to
specify Link Type.
0, disable
1, 64kbps
2, 128kbps
3, BOD
<oname=>: Enter oname=dial-out username (e.g.,
oname=admin).
<opwd=>: Enter opwd=dial-out password (e.g., opwd=1234).
<pauth=>: Enter pauth=pc or pauth=p to set PPP
authentication. In which, pc means PAP&CHAP, p means AP
Only.
<ovj=>: Enter ovj=on or ovj=off to enable/disable VJ
Compression.
<okey=>: Enter okey=IKE Pre-Shared Key to set the PSK (e.g.,
okey=abcd).
<ometh=>: see below
Enter ometh=ah a/m/s/S
(means AH Auto, AH MD5, AH SHA1, or AH SHA2).
Enter ometh=espd a/m/s/S or ometh=espda a/m/s/S
(means ESP DES without or with Authentication Auto/
MD5/ SHA1/ SHA2).
Enter ometh=esp3 or ometh=esp3a a/m/s/S
(means ESP 3DES without or with Authentication Auto /
Vigor2620 Series User's Guide