Gathering The Appropriate Tools; Determining The Orientation Of The Roller; Brushes; Repositioning The Idler Pulley Assembly - Toro Reelmaster 3100-D Series Installation Instructions Manual

1
Gathering the Appropriate
Tools
No Parts Required
Procedure
Acquire the following tools before proceeding with the
installation:
•
1/2 deep-well socket
•
9/16 socket
•
5/8 socket
•
1/2 wrench
•
9/16 wrench
•
1/8 Allen wrench
•
5/16 Allen wrench
•
3/8-16 tap
•
12 inch straight edge (Toro Part 114-5446)
•
Torque wrench (foot-pound)
•
Torque wrench (inch-pound)
•
Blue 242 Loctite
2
Determining the Orientation of
the Roller Brushes
No Parts Required
Procedure
All cutting units are shipped with the counterweight mounted
to the left end of the cutting unit. Use the
determine the position of the roller brushes and reel motors
for Reelmaster 3100-D or
Figure 1
Figure 2 for Reelmaster 7000-D.
1. #1 cutting unit
2. #2 cutting unit
3. #3 cutting unit
1. #1 cutting unit
2. #2 cutting unit
3. #3 cutting unit
4. #4 cutting unit
Note: These instructions and illustrations show the
installation of the kit on cutting units with the end weights
mounted on the left end of the cutting unit.
3
Repositioning the Idler Pulley
Assembly
to
No Parts Required
Procedure
On the left front and left rear cutting units, reverse the idler
pulley assembly to mount on the right end of the cutting unit
(Figure 3), as follows:
3
Figure 1
Reelmaster 3100-D
4. Left-hand roller brush
drive assembly
5. Reel motor
6. Right-hand roller brush
drive assembly
Figure 2
Reelmaster 7000-D
5. #5 cutting unit
6. Reel motor
7. Right-hand roller brush
drive assembly
8. Left-hand roller brush
drive assembly