To 012-131 Horizontal Transport Entrance Sensor Jam Rap - Xerox VersaLink B7025 Service Manual

012-111 to 012-131 Horizontal Transport Entrance Sensor
Jam RAP
BSD-ON: BSD 13.5 Office Finisher LX Horizontal Transport
012-111 The horizontal transport entrance sensor did not deatuate within the specified time.
012-112 After the fuser exit sensor was actuated, the horizontal transport entrance sensor did
not deatuate within the specified time.
012-126 After the horizontal transport entrance sensor was actuated, the horizontal transport
entrance sensor did not deactuate within the specified time.
012-131 After the fuser exit sensor was actuated, the horizontal transport entrance sensor did
not deatuate within the specified time.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Check the horizontal transport drive rolls,
ination. Check for obstructions or damage in the paper path. The paper path is good.
Y N
Clean or install new components as necessary.
Enter dC330 code 012-190. Actuate the horizontal transport entrance sensor,
6. The display changes.
Y N
Check the wiring between J8861 pin 2 and
loose or damaged connector. The wiring is good.
Y N
Reconnect or repair as necessary.
Measure the voltage between P8987
approximately +5VDC.
Y N
Install a new finisher PWB, PL 13.45 Item
Measure the voltage between P8987
horizontal transport entrance sensor. The voltage changes.
Y N
Install a new horizontal transport entrance sensor,
Install a new finisher PWB, PL 13.45 Item
Switch off the machine, GP 10. Open the horizontal transport top cover. Cheat the horizontal
transport interlock sensor. Switch on the machine,
driven.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
PL 13.08 and nip rolls, PL 13.07 for wear or contam-
PL 13.08 Item
P8987 pin 6 for an open or short circuit, or a
pins 4 and 5 on the finisher PWB. The voltage is
2.
pin 6 on the finisher PWB and ground. Actuate the
PL 13.08 Item 6.
2.
GP 10. The horizontal transport belt is
Y N
Check the wiring between
finisher PWB for an open or short circuit, or a loose or damaged connector. The wiring
is good.
Y N
Reconnect or repair as necessary.
Measure the resistance of the horizontal transport motor between
and 6. The resistance is approximately 20 Ohms.
Y N
Install a new horizontal transport motor,
Install a new finisher PWB,
transport motor, PL 13.08 Item
Check the horizontal transport entrance sensor and horizontal transport Motor circuits for an
intermittent condition. If the fault persists, install a new finisher PWB,
April 2017
2-79
P/J8862 on the horizontal transport motor and
PL 13.08 Item 13.
PL 13.45 Item 2. If the fault persists, install a new horizontal
13.
PL 13.45 Item
Status Indicator RAPs
012-111 to 012-131
P8987 on the
P/J8862 pins 1, 2, 5
2.