To 103-313 Hybrid Water Mark Rap - Xerox VersaLink B7025 Service Manual

103-310 to 103-313 Hybrid Water Mark RAP

103-310 The secure watermark kit cannot be made available because the hybrid watermark
detection hardware is not installed.
103-311 The secure watermark Kit is not enabled.
103-312 The secure watermark kit cannot be made available because the hybrid watermark
detection hardware for document side 2 is not installed.
103-313 The secure watermark kit did not become available because of insufficient IISS exten-
sion memory.
Procedure
For information only. No service action necessary.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
103-314 Prohibited Originals RAP
103-314 Possible prohibited originals (system fail).
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Initialise the hard disk, refer to
4. Reload the software, GP 4.
5. If the fault persists, install new ESS PWB,
April 2017
2-501
WARNING
GP 10. Disconnect the power cord. Electricity can cause
GP 10.
PL 1.10 Item 3 and the ESS PWB,
dC355 Image Disk Diagnostics.
PL 3.10 Item 6.
Status Indicator RAPs
103-310 to 103-313, 103-314
PL 3.10