Xerox VersaLink B7025 Service Manual page 752

Replacement
1. Route the harness through the wire guides and connect the proper connectors to the no
paper sensor, tamper home sensors and tamper motors.
2. Place the compiler tray assembly into position.
3. Install the set clamp shaft front end into the front frame,
a. Insert the front end of the shaft into the front frame (1).
b. Slide the shaft toward the front until the rear end of the shaft can be inserted into the
rear frame (2).
Figure 11 Set clamp shaft installation
Repairs and Adjustments
REP 13.17
4.
Figure 11:
April 2017
4-112
Slide the three set clamp holders with springs (1) into the correct location on the shaft,
Figure 12.
Figure 12 Preparing to install the holder springs
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Launch Issue