Power On H Transport Entrance Sensor - Xerox DocuColor 2240 Service Manual

12-901 Power On H Transport Entrance Sensor

The H Transport Entrance Sensor detected a paper at power on, when all the interlock were
closed, or at initialization.
Procedure
Enter dC330 [012-103] and press Start. Actuate the H Transport Entrance Sensor
The display changes.
Y N
Disconnect P/J845 from Finisher Control PWB. Measure voltage at P/J845-A4. +5 VDC
is measured.
Y N
Replace Finisher PWB (PL 17.13)
Check the wire from P/J845-A4 to P/J854-2 on the H Transport Entrance Sensor for an
open circuit (Figure 2). If the wire is good, replace the H Transport Entrance Sensor
17.4).
Check that the voltage at the customer outlet is in specification and does not drop during
machine start.
Entrance
Sensor
Figure 1 Component Location
Status Indicator RAPs
12-901
(Figure
(Figure 3).
1).
Figure 2 12-901 RAP Circuit Diagram - H Transport Entrance Sensor
(PL
09/03
2-284
Figure 3 Finisher PWB
DC 3535/2240/1632, WC M24
Initial issue