REP 13.12 Stacker Upper Cover
Parts List on
PL 13.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1.
Remove the stacker tray,
REP
13.20.
2.
Remove the stacker lower cover,
REP
3.
Remove six screws (1), then the stacker upper cover (2),
Figure 1 Stacker upper cover removal
Replacement
The replacement is the reverse of the removal procedure.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP
10. Disconnect the power cord
13.11.
Figure
1.
REP 13.13 Stack Height Sensors 1 and 2
Parts List on
PL 13.27
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1.
Remove the rear upper cover,
2.
Remove the relevant stack height sensor,
a.
Disconnect the relevant connector (1).
b.
Remove either stack height sensor 1 (2) or stack height sensor 2 (3).
Replacement
The replacement is the reverse of the removal procedure.
April 2017
4-103
WARNING
GP
10. Disconnect the power cord
REP
13.7.
Figure
1:
Figure 1 Sensor removal
Repairs and Adjustments
REP 13.12, REP 13.13