Xerox VersaLink B7025 Service Manual page 787

2. Wind the extension spring loop end of the carriage cable around the capstan,
a. Wind the cable (1) 2.5 turns.
b. Use adhesive tape (2) to affix the extension spring loop end of the cable to the
frame.
Figure 7 Capstan winding (1)
3. Wind the end-ball end of the carriage cable around the capstan,
a. Wind the cable (1) 3 turns.
b. Use adhesive tape (2) to affix the cable to the capstan.
Figure 8 Capstan winding (2)
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure 7: 4. Figure 9
5. Install the end-ball end of the carriage cable,
a.
b.
Figure 8:
April 2017
4-147
shows the correct arrangement of the cables, front and rear.
3 Turns
Color: Black
2.5 Turns
3 Turns
Color: Silver
2.5 Turns
Figure 9 Cable arrangement
Wrap the cable on the pulley at the front of the half rate carriage (1).
Put the end-ball in the notch in the frame (2).
Figure 10 End-ball end installation
Rear
Front
Figure 10:
Repairs and Adjustments
REP 60.3