Table of Contents
Advertisement
Hyper-NAT Refinements
E-DOC-CTC-20051017-0155 v1.0
The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts
to share a single (remotely negotiated) public IP address.
In case Hyper-NAT is enabled on the WAN interface that will be used for remote
management, and a static mapping has been made to allow remote hosts to
address regular HTTPs services on a host residing on your local network, you must
make sure that accessing the SpeedTouch™ Web Interface is still possible.
For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT
Configuration Guide.
The default port for the HTTPs server is set to 443. This can be changed by
executing the following command:
=>:service system modify name=HTTPs state=enabled port=448
=>
The command above will change the HTTPs server port of the SpeedTouch™ from
port 443 (default) to port 448.
=>:service system list name=HTTPs expand=enabled
Idx Name
Protocol
-----------------------------------------------------------------------
1 HTTPs
tcp
Description............... HTTP web server over ssl
Properties................ server
Attributes................ state port aclip aclif aclifgroup map log
User Managed Attributes... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port.......................
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan wan
Map List...................
Logging.................... disabled
=>
NAT-refinements for SpeedTouch™ services should
!
NAT configuration menu, but
SpeedTouch™ Remote Access
SrcPort
DstPort
Group
448
448
448
never
always
in System Services.
Chapter 8
be made in the
87
Advertisement
Table of Contents
