Table of Contents
Advertisement
Chapter 10
SpeedTouch™ Monitoring
Procedure
154
The general flow of user configuration is as follows: you create a view, which is
basically a set of MIB access rights. after that, you create a user group with access
to that view. Then, you create a user and add it to the group. Thus, the user will
have the groups MIB access and have tha access rights you defined in the view.
Proceed as follows:
Step
Action
1
Use the following command to create a new view:
:snmp view add viewname=View_All viewtree=iso type=include
2
Use the following command to create a new group with read-, write-
and notification access to that view:
:snmp group add groupname=Grayskull securitymodel=usm
securitylevel=noAuthNoPriv readview=View_all writeview=View_all
notifyview=View_all
3
Use the following command to create a new user:
:snmp user add securityname=Musclor snmpengineID=localSnmpID
authprot=usmNoAuthProtocol privprot=usmNoPrivProtocol
4
Use the following command to add the user to the group:
:snmp securitytogroup add securitymodel=usm
securityname=Musclor groupname=Grayskull
5
Use the following command to enable the SNMP service if necessary:
:service system modify name SNMPV3_AGENT state enabled
For a more detailed description of these commands and their parameters, refer to
the CLI command guide.
E-DOC-CTC-20051017-0155 v1.0
Advertisement
Table of Contents
