THOMSON Wireless Business DSL Routers SpeedTouchTM620 Operator's Manual page 69

Setting the time via CLI
SNTP via the CLI
E-DOC-CTC-20051017-0155 v1.0
The
:system rtc settime
real-time clock settings and to configure them:
=>:system rtc settime
date = 04/07/2003
time = 10:34:55
timezone = +01:00
daylightsaving = off
=>
You can also use this CLI command to manually set the SpeedTouch™ internal real-
time clock:
=>:help system rtc settime
Set/Get date, time, timezone, daylight savings time
Syntax : settime [date = <dd/mm/yyyy>] [time = <hh:mm:ss>]
[timezone = <(+ or -)hh:mm>]
[daylightsaving = <{disabled|enabled}>]
Parameters :
[date = <dd/mm/yyyy>]
Set the system date
[time = <hh:mm:ss>]
Set the system time
[timezone = <(+ or -)hh:mm>]
Set the system timezone(-12:00...+14:00 / 15 minute resolution)
[daylightsaving = <{disabled|enabled}>]
Enable/Disable daylight saving
The SpeedTouch™ SNTP client is configured via the
=>:sntp help
Following commands are available :
add : Add NTP server
list : List the NTP servers
delete : Delete NTP server from list
flush : Flush NTP server list and SNTP client configuration
config : Modify/Display configuration
You can use the following commands:
:sntp list
List the configured NTP servers.
:sntp add and :sntp delete
Add or delete NTP servers.
:sntp config
Enable/disable the SpeedTouch™ SNTP client and set the polling interval.
CLI command allows you to overview the current
:sntp
Chapter 6
SpeedTouch™ System Services
CLI command group:
59