Table of Contents
Advertisement
Chapter 10
SpeedTouch™ Monitoring
Syslog host on a
remote network
168
The default SYSLOG SpeedTouch™ service is configured to allow traffic from the
SpeedTouch™ syslog daemon towards the WAN:
=>:service system list name=SYSLOG expand=enabled
Idx Name
Protocol
te
-----------------------------------------------------------------------
1 SYSLOG
udp
bled
Description................ System Logging Events
Properties................. client
Managed parameters......... state srcip
Source Ip Selection........ auto
Interface Access List...... any
Ip Access List............. any
=>
Therefore, no additional configuration is needed in case you want to configure a
syslog host on a remote network.
The example below shows the syslog rule to add for a syslog host with IP address
192.6.11.1. The local syslog host (192.168.1.10), configured before (See
host on the local
network") will receive all generated syslog messages; the remote
syslog host only receives syslog messages from all facilities with severity warning,
error, critical, alert or emergency (all facilities, with severity warning and higher):
=>:syslog ruleadd fac=all sev=debug dest=192.6.11.1
=>:syslog list
1: all.debug
2: all.debug
=>
SrcPort
DstPort
514
192.6.11.1
192.168.1.10
Group
Sta
ena
" Syslog
E-DOC-CTC-20051017-0155 v1.0
Advertisement
Table of Contents
