Resetting The Speedtouch - THOMSON Wireless Business DSL Routers SpeedTouchTM620 Operator's Manual

13 Resetting the SpeedTouch™

Introduction
Normal reboot
Reset to factory
defaults
E-DOC-CTC-20051017-0155 v1.0
If needed you can reset the SpeedTouch™ to factory defaults or just reboot.
To reboot the SpeedTouch™ without erasing the current configuration,use the
following command:
=>:saveall
This command will save the current configuration to the user.ini file.
Now enter the following command:
=>:system reboot
This command will reboot the SpeedTouch™ and will load the user.ini file upon
reboot so the previous saved configuration will be restored.
To reset the SpeedTouch™ to factory defaults, usethe following command:
=>:system reset factory=yes proceed=yes
This command will delete the user.ini file (if the previous configuration was saved)
and reboots the SpeedTouch™.
If there is an isp.def file present in the 'dl directory it will load this file. The isp.def
contains an Internet Service Provider specific configuration.
If no ips.def file is present on the device the SpeedTouch™ will reboot with the
hardware defaults.
Chapter 13
Resetting the SpeedTouch™
203