Lan Based Auto-Configuration (Lac) Support (Tr-064) - THOMSON Wireless Business DSL Routers SpeedTouchTM620 Operator's Manual

Chapter 8
SpeedTouch™ Remote Access
About TR-064
Configuration Options
How to Configure LAC:
106
8.7 LAN Based Auto-Configuration (LAC) Support
(TR-064)
The SpeedTouch™ supports the DSL Forum's TR-064 Technical Report on LAN
Based Auto-Configuration. This provides the possibility to automatically configure
the SpeedTouch™ from a management application running on a PC on the
customer premises LAN. For more information, refer to the DSL Forum's Technical
Report TR-064.
Architecture
The diagram below shows the architecture and protocol stack for TR-064 on the
SpeedTouch™:
Service Provider
XML Configuration
CPE Management App
HTTPMU HTTPU
SSDP
PC Operating System
UDP
It is impossible to configure LAC via the Web interface. Only CLI commands can be
used.
No configuration is needed for LAC. It simply needs to be enabled or disabled. From
Syntax the system prompt, use the following command:
[system]=>config
tr64 = disabled | enabled
tr64auth = disabled | enabled
XML-based DSP CPE Management
User Input
XML
SOAP
HTTP
SSL
TCP
IP
Layer 2
SpeedTouch
CPE Software
XML
SOAP
HTTPMU HTTPU
HTTP
SSDP
SSL
UDP
TCP
IP
Layer 2
E-DOC-CTC-20051017-0155 v1.0