Table of Contents
Advertisement
Chapter 8
SpeedTouch™ Remote Access
How to Configure
Parameter Descripion
110
The CLI command uses the following parameters:
CWMP:
Parameter
state
mode
periodicInform
periodicInfInt
sessionTimeout
noIpTimeout
maxEnvelopes
connectionRequest
connectionReqPath
connectionReqUserName
connectionReqPsswd
connectionReqAuth
qos-class
bootdelayrange
Value
Description
enabled or
Enable or disable the CWMP
disabled
daemon
read-only or full
Set the operational mode of
the CWMP daemon to read-
only or full.
enabled or
Enable or disable CWMP
disabled
periodic inform
number
Set the interval between two
periodicInform messages in
seconds
number
Set the HTTP session-timeout
in seconds
number
Set the time (in seconds) the IP
may be 0 after uploading a
new config file
number
Set the maximum number of
SOAP envelopes sent within
one http-message
enabled or
Enable or disable CWMP
disabled
connection request
text string
Set the path where the cwmp
daemon can be reached
text string
Set the username the ACS
must use to log in
text string
Set the password the ACS
must use to log in
none, basic or
Set the authentication type of
digest
modem CWMP server for
asynchronous connects
number
Set the quality of service class
for outgoing CWMP data
number
Set the delay on boot before
inform is sent
E-DOC-CTC-20051017-0155 v1.0
Advertisement
Table of Contents
