THOMSON Wireless Business DSL Routers SpeedTouchTM620 Operator's Manual page 136

Chapter 9
The Integrated SpeedTouch™ ISDN Modem
126
Step Action
8
Click Other.
Result:
9
Select the Mode (On-Demand or Always On)
10
Fill in the idle time limit. If the connection is On-Demand, and the
connection is idle for this amount of time (i.e. no traffic), the connection
shuts down.
The other values are automatically retrieved when the PPP connection is
established.
You cannot enable Callback via the Web interface. For this, you must use
CLI. If you do not enable it, the SpeedTouch™ will establish the ISDN
connection over which the PPP connection is made.
Via CLI
Use the following command sequence to configure the ISDN dial-in connection via
CLI:
[isdn]=>ifconfig
intf
BODstart
callback
[isdn]=>ifconfig
intf = buisdn
[number] = 025292222
[mlppp] =
disabled
[mlppp] = disabled
[BODstart] = 40
[BODend] = 38
[mode] = dialout
[callback] =
disabled
[callback] = disabled
[group] = empty
:isdn ifconfig intf=buisdn mlppp=disabled callback=disabled
[isdn]=>:isdn ifconfig intf=buisdn mlppp=disabled callback=enabled
[isdn]=>saveall
[isdn]=>:ppp
[ppp]=>ifattach intf bu_isdn
the Other page appears:
number
BODend
group
enabled
enabled
mlppp
mode
E-DOC-CTC-20051017-0155 v1.0