Table of Contents
Advertisement
Chapter 10
SpeedTouch™ Monitoring
10.2.9 How to Allow Remote SNMP
About Remote SNMP
It is possible to allow to allow a remote SNMP manager to monitor the
SpeedTouch™. To do this, add the WAN interface to the service access list.
Command
Use the following command:
=>service system ifadd name SNMPV3_AGENT group wan
Receiving Traps
To allow the remote SNMP manager to receive SNMP traps generated by the
SpeedTouch™, no extra configuration is necessary. It is, however, possible to
configure which traps are sent to a manager. For more information, refer to
"10.2.12 How to Configure the Traps" on page
158.
You can also configure authentication for remote access to SNMP. For more
information, refer to
"10.2.11 How to Restrict SNMP Access" on page
157.
E-DOC-CTC-20051017-0155 v1.0
151
Advertisement
Table of Contents
