THOMSON Wireless Business DSL Routers SpeedTouchTM620 Operator's Manual page 119

How to View the
Configuration
How to Configure
CWMP:
Syntax
E-DOC-CTC-20051017-0155 v1.0
From the main prompt, use the following command to view the CWMP Parameters:
=>cwmp
=>[cwmp]config
This results in the following type of output on the screen, providing an overview of
all parameters and their values:
State
Mode
Max Envelopes
Session Timeout
No Ip Timeout
Connection Request Port
Periodic Inform
Periodic Inform Interval
Connection Request
Connection Request UserName
Connection Request PassWord
Connection Request Path
Connection Request Authentication
Qos class
Boot delay range between 0 and
Similarly, to view the CWMP Server configuration, enter the following command
sequence from the cwmp prompt:
=>[cwmp]server
=>[cwmp server]config
From the cwmp prompt, use the following command to configure the CWMP
parameters:
config
[state = <{disabled|enabled}>]
[mode = <{read-only|full}>]
[periodicInform = <{disabled|enabled}>]
[periodicInfInt = <number>] [sessionTimeout = <number>]
[noIpTimeout = <number>] [maxEnvelopes = <number>]
[connectionRequest = <{disabled|enabled}>]
[connectionReqPath = <string>]
[connectionReqUserName = <string>]
[connectionReqPsswd = <string>]
[connectionReqAuth = <{none|basic|digest}>]
[qos-class = <number>] [bootdelayrange = <number>]
SpeedTouch™ Remote Access
: disabled
: full
: 2
: 60
: 10
: 51005
: enabled
: 3600 s
: disabled
:
:
:
: none
: 12
: 0 s
Chapter 8
109