Table of Contents
Advertisement
Chapter 11
SpeedTouch™ Advanced Diagnostics
190
To verify which port is being mirrored (ingress or egress) use the following
commands:
=>:eth switch mirror ingress
Ingress mirror port = 1
=>:eth switch mirror egress
Egress mirror port = 2
=>
When there is no need to mirror traffic to ethernet port four any more you can
disable the mirroring by executing the following command:
=>:eth switch mirror ingress port=1 state=disabled
=>:eth switch mirror egress port=2 state=disabled
E-DOC-CTC-20051017-0155 v1.0
Advertisement
Table of Contents
