Table of Contents
Advertisement
10.4 SpeedTouch™ Identification on AWS
Information Exchange
How to Enable/Disable
the Information
Exchange
Advantages of
SpeedTouch™
Identification
E-DOC-CTC-20051017-0155 v1.0
The SpeedTouch™ exchanges some variables after the DSL synchronisation with
the DSLAM (Digital Subscriber Line Access Multiplexer). These variables are hard-
coded into the SpeedTouch™.
The following variables are exchanged:
Chipset vendor ID:
For example the SpeedTouch™620 chipset vendor ID will be "BCM"
Software version number:
The software version number is retrieved from the ENV variables
_PRODNUMBER + _BUILD.
For example the SpeedTouch™620 software version number will be "620
5.3.2".
Serial number:
The Serial number is retrieved from the ENV variables
BOARDSERIAL_NBR + _PRL.
For example the SpeedTouch™620 Serial number can be
"CP0452JT02D DSLBB620AA".
Self test result:
The self test result will be retrieved from an ENV variable.
It is possible to disable (and re-enable) the sending of the SpeedTouch™
information using the
adsl config
{Administrator}[adsl]=>config
[opermode = <{multimode|multi_adsl2|multi_readsl2| multi_adsl2plus}>]
[trace = <{disabled|enabled}>]
Set the trace variable to
disabled
it.
The SpeedTouch™ identification can be used to:
View the evolution of the network to an open CPE market.
Streamline customer support operation, and so it is mandatory to see which
CPE is attached to a certain port on the DSLAM.
CLI command:
to disable the sending, or to
Chapter 10
SpeedTouch™ Monitoring
enabled
to re-enable
169
Advertisement
Table of Contents
