Table of Contents
Advertisement
Configuration via
CLI commands
E-DOC-CTC-20051017-0155 v1.0
To have HTTPs access via WAN, additional configuration of the HTTPs service is
needed.
Use the following CLI command to allow HTTPs access from the WAN to the
SpeedTouch™:
=>:service system ifadd name=HTTPs group=wan
=>
If you take a look at the HTTPs service configuration, you will see that the
group is added to the Interface Access List:
=>:service system list name=HTTPs expand=enabled
Idx Name
Protocol
-----------------------------------------------------------------------
1 HTTPs
tcp
Description............... HTTP web server over ssl
Properties................ server
Attributes................ state port aclip aclif aclifgroup map log
User Managed Attributes... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 443
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan
Map List................... 443
Logging.................... disabled
=>
SpeedTouch™ Remote Access
SrcPort
DstPort
Group
443
wan
Chapter 8
wan
85
Advertisement
Table of Contents
