Table of Contents
Advertisement
Chapter 8
SpeedTouch™ Remote Access
Configuration via
CLI commands
94
To have SSH access via WAN, additional configuration of the SSH service is needed.
Use the following CLI command to allow SSH access from the WAN to the
SpeedTouch™:
=>:service system ifadd name=SSH group=wan
If you take a look at the SSH service configuration, you will see that the
is added to the Interface Access List:
=>:service system list name=SSH expand=enabled
Idx Name
Protocol
----------------------------------------------------------------------
1 SSH
tcp
Description................ SSH server
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log
User Managed Attributes.... state aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 22
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan
Map List................... 22
Logging.................... disabled
SrcPort
DstPort
Group
22
wan
E-DOC-CTC-20051017-0155 v1.0
wan
group
Advertisement
Table of Contents
