Table of Contents
Advertisement
Chapter 4
SpeedTouch™ Configuration Management
Applying a configuration
stored on the
SpeedTouch™
38
To activate a configuration file, stored on the SpeedTouch™ '/dl' subdirectory, the
CLI command
:config load
Below the syntax of the config load CLI command is provided:
=>help config load
Load saved or default configuration.
Syntax : load [load_ip = <{disabled|enabled}>]
[defaults <{disabled|enabled}>] [flush = <{enabled|disabl
ed}>]
[echo = <{disabled|enabled}>] [filename = <string>]
Parameters :
[load_ip = <{disabled|enabled}>]
Load IP settings or not.
[defaults <{disabled|enabled}>]
Load default instead of saved configuration.
[flush = <{enabled|disabled}>]
Flush current configuration before loading new one.
[echo = <{disabled|enabled}>]
Echo each command string when loaded.
[filename = <string>]
Configuration filename.
Proceeding from the same FTP session you opened in the previous procedure, enter
the
quote site config load
previously put on the SpeedTouch™ file system:
ftp> quote site config load
200-
200 CLI command "config load" executed
For more information on the config load options,
configuration stored on the SpeedTouch™" on page 32
is used.
command to load the configuration you
see" Applying a
E-DOC-CTC-20051017-0155 v1.0
Advertisement
Table of Contents
