Mitel SX-200 Practices page 1175

El .
DATASET 2100 Series Description
Table 15-2 lnstallatlon Of A Rack Mownted Dataset 2102
Step Action
1. Complete system cabling and Customer Data Entry for the slot into which the dataset is
being installed; cabling is defined in DATASHELF 9100 installation procedures.
-2.
3.
Set the eight DIP switches as required for this installation. Refer to Table 15-l.
Install a Rack Mounted DATASEr 2102 by plugging it into its assigned slot in the DATA-
SHELF 9100; these assignments are done when the system is configured. All LEDs
should flash 5 times, indicating that the dataset has passed its self-test. If this does not
happen, the dataset is faulty and must be replaced.
4.
Ensure the POWER 1 LED is on continuously, indicating no open fuse within the data set;
if off, a fuse is open or there is a fault in the wiring connection.
5. Plug the RS-232 interconnecting cable into the RS-232 connector at the back of the
Rack Mounted DATASET 2102 and connect it to the host device. When the RS-232 con-
nector is attached, the DEVICE LED should be on, unless the device is an auto-answer
device, and defined as such in CDE (usually only destination devices such as host com-
puters are auto-answer). If the device is not auto-answer, and the DEVICE LED does not
come on, make sure the device is powered on, and then use an RS-232 break-ut box
to verify that the device provides DTR. If the device does not provide DTR, select CDE
option 'IRS-232 Force High" for that device.
Install Modem Pooling: Rack Mounted DATASET 2102
Notes: 1. A modem pool allows a user with a terminal at their desk to access remote
devices (such as a computer in another city). The terminal sends data
information to datasets and a modem. The modem converts the data information
from the terminal into voice information. This voice information goes to an ONS
line port on the SX-200 DIGITAL PABX, and then to a trunk on the public
switched network. The dataset (associated with a digital line card), the modem,
and ONS port together make up a pooled modem. Each pooled modem supports
one call. A group of pooled modems can support many calls, and is known as a
modem pool.
2, The DATASEr 2102 is a circuit card for the DATACABlNEr 9000. The card is
most often used to interface a host computer to a digital line port on the
SX-2UCJ DIGITAL PABX. It has a voice channel, a data channel, and a control
channel.
3, The card is mounted in the 19-m. DATASHELF 9100 rack. Up to three racks can
be mounted in the DATACABINET 9000.
9109496-I 26-NA Issue 1 Revision 0 126 15-9