Test Procedures - Mitel SX-200 Practices

El .
SUPERSET 3 Description
Wall-Mounting the SUY9SSH3 Telephone
Wall-Mounting Instructions
4.5 SUPERSET 3 telephone may be attached to a wall-mount assembly and plugged
into a modular wall jack. The wall-mount assembly can be ordered through normal
distribution channels.
Test Procedures
:
\ 4.6 Perform the test procedures listed in Table 4-2 as operational tests when installing a
SUPERSET 3 telephone after initial installation of a system.
Whenever a SUPERSET 3 telephone is connected to an operating system, or the
system has just been powered up, the test is run automatically and the following results
appear, If any test fails, verify that the system is installed correctly and is powered up.
Table
4-2 SUPERSET
3 Telephone Power-n Test
TEST LED1 LED2 LED3 TIMING
1 on on on 1 second
2 flashing
Off Off
1 O-l 5 seconds
3
Off Off Off
steady, if set is on-hook
or on
Off Off
steady, if set is off-hook
Note: If all LEDs turn on steady for more than a few seconds there is an error; check wiring, then try
a known good spare.
If the system is programmed to detect a missing SUPERSfl 3 telephone, verify
operation of this feature as follows:
. Disconnect the SUPEWET3 modular plug.
9 A minor alarm appears at the console.
l
At the console, press the ALARM key; display indicates disconnected telephone.
* At the console, clear the alarm.
0 Reconnect the modular cord to the SUPEFfSfl3 telephone.
9109-09&126-NA
Issue 1 Revision 0
126 4-7