Mitel SX-200 Practices page 1057

m .
Attendant Console
Installing a SU/W?CO/VSOLE RXXI Attendant Console
Any connection of this console to an off premise application, an out of plant
application, or to any other exposed plant application may result in a safety
hazard, and/or defective operation, and/or equipment damage.
Notes: 1. The SUR3ICONSOLE 1000 Attendant Console uses a two-wire connection to
connect to one circuit on a digital line card (Tip to Tip and Ring to Ring.) The
digital line card must be in a high-powered slot. Four consoles are allowed per
digital line card.
,
2. The system maximum is 11 consoles.
3.
The
SUPERCONSOLE
7000 Attendant Console can be used in the maintenance
terminal port. The system default programming must be changed to allow this.
Refer to 9109-094-2OCkNA, Installation Information.
4. The console operates in either English or French.
5. The console has a programmable printer port.
CROSS
CONNECT
FIELD
MODULAR
JACK
CONNECTORIZED
CABLE
MAXIMUM lfX0 M 24
AWG
tlWlSTED PAIR\
22 AWG wlD
STATkIN WIRE
ORTWISTED PAIR
xl M MAXIMUM
SJPERCOt6OLE 1Cm
.-..-..--- ..-- .-
NOE USE ONLY MITELCABLE-FOR
Al I LNJrnl WMLt
THE CONSOLE t/ODM C0Fri-h
DlGbU LINE CARD
Figure 2-5 SUERCONSOLE 1000 Attendant Console Installation
9109-096126-NA Issue 1
Revision 0 126 2-7