Mitel SX-200 Practices page 1092

Peripheral Devices
Any connection of this set to an off premise application, an out of plant appiica-
tion, or to any other exposed plant application may result in a safety hazard,
and/or defective operation, and/or equipment damage.
Do not use a hand-telephone test set (butt set) to check a SUPERSET3DN line.
The interface card has no loop detector. Set on-hook / off-hook status is sig-
-.- naied by data transmission.
- Do not connect SUfJERSET3DN telephones to standard lines, in parallel, or as
\
power fail transfer extensions.
Before the set can be used, the system must be programmed and equipped with DNI
Line cards to interface with a
SUPERSET
3 DN telephone. The
SUPERSET 3
DN
telephone is not available with Generic 1001. Refer to Practice 9109-096-210-NA,
Customer Data Entry.
Step
1.
2.
3.
4.
5.
Table 6-l SUPfRSET 3 DN Telephone installation instructions
Action
Place the SUPERSET 3 DN telephone in its assigned position.
Connect the handset cord to the handset and main assembly,
identify the set's telephone number, extension number, other line appearances and
features on the identification Card.
install the identification Card and the protective cover onto the main assembly.
Connect the line cord to the telephone and the telephone jack.
Table &2 SUPERSET 3 DN Telephone Environmental Specifications
Operating Environment:
Temperature:
Humidity:
Storage/Shipping Environment:
Temperature:
Humidity:
4O to 4!Y c (39.2O to 1 2o" F) .
10% to 90% RH, non-condensing.
-40' to 60" C (-40' to 150' F).
10% to 90% RH, non-condensing,
126 6-6 Revision 0 9109-096-126-NA issue 1