Superset Dss Module Installation Instructions - Mitel SX-200 Practices

Peripheral Devices
Table 8-l
SUPERSET DSS
Module Specifications
item
Dimensions
Specification
Lerrgth
Width
Height
interface
240 mm (9.45 inches)
155 mm (6.10 inches)
106 mm (4.17 inches)
,
Loop length (maximum)
910 meters (3000 ft), 26 gauge single twisted pair for
signal and power,
Power Line powered from PABX DNI Line card.
SUPERSET DSS Module Installation Instructions
Any connection of thls device to an off premise application, an out of plant
application, or to any other exposed plant application may result In a safety
hazard, and/or defective operation, and/or equipment damage.
The rules for cable lengths between the PABX and the
SUPERSET DSS
Module
must be followed for proper operation; refer to Appendix A.
Any connection of this
SUPERSET DSS
module to an off premise application,
an out of plant application, or to any other exposed plant appiicatlon may result
in a safety hazard, and/or defective operation, and/or equipment damage.
Chart 8-l Install a
SUPERSET DSS
Module
Step Actlon
1.
Unpack the SUPERSET DSS Module and position it
: neA to an Attendant Console or a SLJPER!3ET
telephone.
2. Plug the SUPERSET DSS Module modular cord into
the jack on the base of the SUPERSET DSS Module
and into its assigned modular telephone jack; it
connects to one circuit on a Digital Line Card.
126 6-4
Comments
The SUPERSET DSS Module and
its associated Console or
SUPERSETtelephone each has a
line cord which connects it to the
PABX.
Page 1 of 2
Revision 0 9109-096-l 26-NA Issue 1