Mitel SX-200 Practices page 1058

Peripheral Devices
Chart 2-2 Install SUPERCOMSOLE 1000 Attendant Console
Step
1.
2.
3 *\
4.
5.
6.
7.
6.
9.
IO.
e
11.
126 2-6
Actlon
Inventory, Unpack, Inspect
Check off received items against packing list and
equipment list, above.
Unpack cartons.
Tag defectiie items.
Fill in relevant portion of damage report.
Repack tagged items and return according to
local procedures.
Assemble Console
Connect the headset (or handset) to its cord.
Plug the cord into the jack at the side of the
console.
Posltlon Console
Put the console in its assigned position. Refer to
9109-094-2OO-NA, Installation Information,
Plug one end of the console modular cord into
the jack at the back of the console, and the other
end into its assigned modular telephone jack.
Connect Console
Connect the modular telephone jack to the
cross-connect field .
Connect the cross-connect field to a digital line
port on a digital line card .
Comments
Packaging is shown in Figure 2-4,
The two jacks are connected in
parallel; either can be used.
Maximum loop length is 1000 m
(3300 ft). Figure 2-!? shows
console positioning and maximum
cable lengths.
The console jack is marked LINE
PORT.
The green lead connects through
the cross-connect field to a Tip
circuit on the digital line card.
The red lead connects through the
cross-connect field to a Ring
circuit on the digital line card.
Page 1 of 2
Revision 0
9109-096-l 26-NA Issue 1