Mitel SX-200 Practices page 1078

Peripheral Devices
S#WEEM Telephone Installation Instructions
5.4 Installation includes unpacking the set, assembling the set and connecting the set to
a wall jack. The connections to the system via the cross connect field are described
in Practice 9109-096-200-NA, Installation Information.
piiiq
Any connection of this set to an off premise application, an out of plant applica-
tion, or to any other exposed plant application may result In a safety hazard,
and/or defective operation, and/or equipment damage.
r--E&--i-
Do not use a hand-telephone test set (butt set) to check a
SUPERSET
line.
The Interface card has no loop detector. Set on-hook / off-hook status Is slg-
naled by data transmission.
Do not connect
SUPERSET
telephones to standard lines, In parallel, or as
power fall transfer extensions.
Before the set can be used, the system must be programmed and equipped with
six-circuit COV Line cards, or eight-circuit SUPE/?SE~Line cards to interface with a
SUPERSE~4 telephone. Refer to Practice 9109-096--210--NA, Customer Data Entry.
Chart 5-l
SUPERSET
4Telephone lnstallatlon lnstructlons
Step
1.
2.
3.
4.
5.
Actlon
Place the
SUPERSET
telephone in its assigned position.
If required, assemble the rear support to the set (refer to Figure 5-4) by inserting the
lugs into the set's base-mounting holes, and pressing the two parts together.
Conneot the handset cord to the handset and main assembly.
Write the user's telephone number on the Number Identification Card,
Identify the set's extension number, other line appearances and features on the
Line Identification Card.
6. Install the Number Identification Card, the Line Identification Card, and their proteotive
lenses onto the main assembly.
7.
6.
Connect the line cord to the telephone and the telephone jack.
After two to four seconds, set identification is displayed, followed by the time and
date.
126 5-6 Revision 0 91 Og-O%-126-NA Issue 1