Mitel SX-200 Practices page 1153

ia .
DATASET 1100 Series Description
The DATASET 1101 Cartridge has two connectors at the back of the set; an W-232
connector and a power connector. It also has an internal ribbon cable connecting it to
the telephone set; its connection to the PABX is through the set's twisted pair.
Any connection of thls device to an off premlse application, an out of plant
application, or to any other exposed plant application may result In a safety
hazard, and/or defective operatlon, and/or equlpment damage.
The DATASEr 1101 Cartridge is internal to the telephone set; only two connections
(power and W-232) are required, in addition to the set's connection to the PABX.
I , Complete Customer Data Entry for the system to allow the DATASET I 101 Cartridge
to operate with the PABX.
2. Connect an W-232 cable between the RS-232 connector at the back of the set and
the peripheral device.
3, Plug the power supply into an ac outlet and plug its cord into the power socket on the
DATASET II 01 Cartridge. Both LEDs should be ON,
4 Plug the telephone set's cord into its jack, which connects to the Digital Line Card at
the PABX; the telephone set should be operational now.
All LEDs should flash five times, indicating that the dataset has passed its self-test. If
this does not happen, the telephone set is faulty and must be replaced.
After the self-test, the TxD LED should be on, unless the device is an auto-answer
device, and defined as such in CDE (usually only destination devices such as host
computers are auto-answer). If the device is not auto-answer, and the TxD LED does
not come on, do the following:
I. Make sure the device is powered on
2. Use an RS-232 break-out box to verify that the device attached to the dataset pro-
vides DTR. If the device does not provide DTR, select CDE option 'IRS-232 Force
High" for that device.
910949&l 26-NA
Issue 1 Revision 0 126 14-3