Rs-232C Connector - Mitel SX-200 Practices

El .
Attendant Console
Step
12.
13.
14.
Chart
2-2
Install
SUPERCONSOLE 1000
Attendant Console
(continued)
Action
Connect the Printer (Optional)
Zonneot the printer to the W-232 printer
connector on the back of the console.
Set the printer baud rate.
Cross Connect
tt the distribution frame, cross connect the cable
from the modular jack to the cable from the digital
line port on the digital line card.
Comments
Pin Signal
1 frame ground
2 transmit data
3 receive data
4
ready to send
5 clear to send
6 data set ready
7 signal ground
a carrier detect
20 data terminal ready
Maximum 50 ft between the printer
and the printer port on the
SUPERCONSOLE 1000
Attendant
Console.
Maximum baud rate is 2400 baud.
Refer to 9109-42OO-NA,
Installation Information, Section 5
gives cross-conneot cabling
information.
Page 2 of 2
RS-232C Connector
2.3 A printer can be attached to the SUERC0/VS0E 7UOO Attendant Console via its
RS-232C port connector, which allows direct connection to most printers, The
FE-232C interface is programmable from 110 to 2400 baud, and acts like a
DATASET I 101 cartridge, with the following exceptions:
l
no autobaud
l
device ID different from that of data cartridge
l
no data loopback test.
The RS-232C connector (J3) is configured such that the console is the data
communications equipment (DE). This allows direct connection to most serial
printers. The following table lists the RS-232C pins recognized by the console's printer
port.
9109-096126-NA Issue 1
Revision 0 126 2-9