Mitel SX-200 Practices page 1156

Perioheral Devices
- POWER I - (CARD FUSE O.K. INDICATION)
2 - DC2 (CARD SYNC WITH PABX INDICATION)
The connectors on the back of a DATASET 1102 Dual Rack Mounted card are:
- RS-232 connector (I)
- RS-232 connector (2)
- shelf backplane connector, J5 (power and Tip-Ring pairs)
The pinouts of the card edge connector, J5, are as follows:
Pin Signal
I data tip
2
no connection
3
frame ground
4 signal ground
5
Tl (ac input)
6
T2 (ac input)
7
T2 (ac input)
8 Tl (ac input)
9
signal ground
IO frame ground
II no connection
12
data ring
Installation
Any connection of this device to an off premise application, an out of plant
appkation, or to any other exposed plant application may result In a safety
hazard, and/or defective operation, and/or equipment damage.
Complete system cabling and Customer Data Entry for the slot into which the dataset
is being installed; cabling is defined in DATASHELF 9100 installation procedures,
e
Install a DATASET 1102 Dual Rack Mounted card by plugging it into its assigned slot
in the DATASHELF 9100. All LEDs (except POWER I) should flash five times,
'indicating that the dataset has passed its self-test. If this does not happen, the dataset
is faulty and must be replaced.
The POWER 2 LED should be on continuously, indicating connection to the DNI Line
Card. If the POWER 2 LED is flashing, check the wiring between the dataset and the
PABX, and Customer Data Entry (CDE) for the device.
Plug the RS-232 interconnecting cables into the RS-232 connector at the back of the
DATASET II 02 Rack Mounted cards and connect them to the host device. When the
RS-232 connector is attached, the DEVICE LED should be on, unless the device is an
auto-answer device, and defined as such in CDE (usually only destination devices
such as host computers are auto-answer). If the device is not auto-answer, and the
DEVICE LED does not come on, do the following:
126 14-6
Revision 0
9109-096-12&NA Issue1