Mitel SX-200 Practices page 1172

Peripheral Devices
Table 16-I DATASET 2100 Dip Switch Settings
(continued)
SWITCH SYNCHRONOUS MODE ONLY
5
DOWN TFIANSPARENT MODE
UP -
SWITCH 6 SWITCH 7 SWITCH 6
X.31 MODE
SYNC SPEED
\
DOWN DOWN DOWN
1200
UP DOWN DOWN 2400
DOWN UP DOWN 4800
UP UP DOWN 9600
X X UP
19200 (X = don't care)
Page 2 of 2
Notes: 1, PARAMETER CHANGES MUST BE FOLLOWED BY A POWER RESET',
2. ALL SWITCH PARAMETERS, EXCEPT SWITCH 1 CAN BE OVERRIDDEN BY THE PABX CDE PA-
RAMl3ERS.
Rack Mounted DATASET 2102 Description
15.9 The primary function of a Rack Mounted DATASET 2102 is to interface between a
host computer and the PABX; Standalone DATASET 2103s distributed throughout
the building access the Rack Mounted DATASET 2102s through the PABX. The Rack
Mounted DATASET 2102 is installed in a DATASHELF 9100 within a DATACABINET
9000, which is usually located within a computer room.
A Rack Mounted DATASET 2102 has LEDs on its front panel, but no switches or keys
for manual operation. Each Rack Mounted DATASET 2102 interfaces to a PABX Digital
Line Card circuit through a single pair. The DATASHELF 9100 connects to the PABX
e
through a 25-pair cable; each card slot is assigned one of these pairs. Figure 15-I
shows a Rack Mounted DATASET 2102. The card measure 254 mm x 190 mm (10 in,
x 7.45 in.).
126 15-6 Revision 0 9109-096-l 26-NA issue 1