Mitel SX-200 Practices page 1128

Peripheral Devices
1 WARNING 1
Any connection of this set to an off premise application, an out of plant applica-
tion, or to any other exposed plant application may resuit in a safety hazard,
and/or defective operation, and/or equipment damage.
Do NOT connect SUPERSET telephones in parallel, to standard lines; or as
power fail transfer extensions. Do not use a hand test telephone (butt-in) to
check a
SUPERSET
telephone line (it's DNI Line Card does not have a loop
detector). The set's on/off hook status is signaled by data transmission.
Before the set can be used, the system must be programmed and equipped with DNI
Line Cards to interface with a SWERSET 470 telephone. Refer to Practice
QlO9-096-210-NA, Customer Data Entry.
Chart 11-l SUPERSET47OTelephone Installation Instructions
Step
1.
2.
3.
4.
5.
6.
7.
Action
Connect the handset cord to the handset and main assembly (See Figure 114).
Write the set's telephone number on the Brand/Extension Card.
identify the set's extension number, other line appearances and features on the
Designation Card.
Install the Brand/extension Card, the Designation Card and the Feature Designation
Card and their protectiie lenses onto the main assembly.
Connect the line cord to the telephone and the telephone jack.
Insert the line cord and the handset cord into the cord channels.
The Message Lamp and the Microphone Lamp will go solid red and the triangular line
appearance indicators will be on for about 5 seconds. When they go out, it indicates
that communication to the PABX has been established.
Table II-I SUPERSET47OTelephone Environmental Specifications
Operating Environment:
Temperature:
Humidity:
Storage/Shipping Environment:
Temperature:
Humidity:
0' to 35' C (32" to 95' F).
0% to 90% RH, non-condensing.
-25' to 70=' C (-13" to 158' F) .
0% to 90% RH, non-condensing.
126 11-8 Revision 0 9109-096-l 26-NA Issue 1