Answeringcalls; Superset; Dn Telephone Installation Instructions - Mitel SX-200 Practices

m .
SUPERSET3DN Telephone
Dial the desired destination number, press Redial or press the appropriate Speed Dial
key, if programmed.
Answering Calls
To answer a call:
.'
Lift the handset or press the SPEAKER key. The set automatically selects the ringing
line. If more than one line is ringing, the set selects the lowest ringing line appearance
key.
or
Press the Line Appearance key to be answered. The call is answered Handsfree. If
desired, lift and use the handset.
Terminating A Call
To terminate a call:
Hang up. If in Handsfree mode, press the SPEAKER key. If there is a call on
consultation hold, the call will ring the set back.
or
Press the CANCEL key. If the set is in handsfree mode, it returns to the idle state; if the
handset is in use, the set returns dial tone. If the set has a call on consultation hold, this
call is reconnected.
When one party hangs up, the remaining party returns to the idle state if in handsfree
mode; if off-hook, the party returns to silence or dial tone, depending on system
options.
Ringer Pitch Adjustment
The SX-2CIO DIGITAL PABX must have an access code assigned to the Tone
Demonstration Package. Dial the access code followed by 33. The set will ring. Press
the Volume Up or Volume Down key to raise or lower the ringer pitch, Each depression
of the key changes the pitch one step. When the ringer sounds as desired, go on-hook
or press the SPEAKER key.
-3 DN Telephone Installation Instructions
6.5 Installation includes unpacking the set, assembling the set and connecting the set to
a wall jack. The connections to the system via the cross connect field are described
in Practice 9109-096-200-NA, Installation Information.
9109-096-126-NA Issue 1
Revision 0
126 6-7