Mitel SX-200 Practices page 1102

Peripheral Devices
SUWZSEU DN Telephone Installation Instructions
7.5 Installation includes unpacking the set, assembling the set and connecting the set to
a wall jack. The connections to the system via the cross connect field are described
in Practice 9109-096--200-NA, Installation Information.
1 WARNING 1
Any connection of this set to an off premise application, an out of plant appiica-
tion, or to any other exposed plant application may result in a safety hazard,
and/or defective operation, and/or equipment damage.
rGG6-j
- Do not use a hand-telephone test set (butt set) to check a
SlJPERSET4
Dh line.
The interface card has no loop detector. Set otiook / off-hook status is sig-
naled by data transmission.
Do not connect
SUPERSET
4 DN telephones to standard lines, in parallel, or as
power fail transfer extensions.
Before the set can be used, the system must be programmed and equipped with DNI
Line cards to interface with a SWERSE7 4 DN telephone. The SWERSE7 4 DN
telephone is not available with Generic 1001. Refer to Practice 9109-096-210-NA,
Customer Data Entry.
Chart 7-l
SUPERSET
DN Telephone installation instructions
Step
I
Action
1.
2.
3.
Place the SUPERSET
DN telephone in its assigned position.
Connect the handset cord to the handset and main assembly.
ldentrfy the set's telephone number, extension number, other line appearances and
features on the Identification Card.
4.
5.
Install the Identification Card and the protective cover onto the main assembly,
Connect the line cord to the telephone and the telephone jack,
Table 7-l
SlJPERSET4
DN Telephone Environmental Specifications
Operating Environment:
Temperature:
Humidity:
Storage/Shipping Environment:
Temperature:
Humidity:
4O to 49O c (39.2O to 120° F).
10% to 90% RH, non-condensing,
-4O'= to 60' C (-40' to
150' F).
10% to 90% RH, non-condensing,
126 7-6
Revision 0 91 Og-096126-NA Issue 1