Mitel SX-200 Practices page 1163

m .
DATASET 1100 Series Description
Installation
1 WARNING 1
Any connection of this device to an off premise application, an out of plant
application, or to any other exposed plant application may result in a safety
hazard, and/or defective operation, and/or equipment damage.
14.9 The following chart lists the steps required to install a MiLink Data Module.
Chart 14-I
M/Link
Data Module installation instructions
,
Step
Action Comment
1. Verii that CDE for the /kfkink Data Module (1101 M) is complete.
2. Connect an AC adaptor between the AC outlet and MiLink Data
Ail LEDs should flash
Module. fiie times, if not
replace the ARtink
Data Module.
3.
Connect a SUPERSET 410, SUPERSET 420, or SUPERSfl430 POWER LED stops
telephone set to the MiLkk Data Module at /UiLinkA or /WLhk B flashing
(another Afj/ink devide can be connected serially to the remaining
/Ktink connection).
4. Connect FIS-232 cable between the MU&Data Module and the Device LED should
peripheral device. be on, see note 1.
Notes: 1. When the RS-232 connector is attached, the DEVICE LED should be on, unless the devfce is an
auto-answer device, and defined as such in CDE (usually only destination devices such as host
computers are auto-answer). If the device is not auto-answer, and the DEVICE LED does not come on,
do the following:
* Make sure the device is powered on.
l
Use an M-232 break-out box to verify that the device provides DTR If the device does not provide
DTR, select CDE option DTR always for that devfce.
2. The POWER LED should be on continuously (except when first connected to AC power), indicating
connection to the Digital Set, If the POWER LED is flashing, check the wiring between the MiLink Data
Module and the set. If the POWER LED continues to flash, verify Customer Data Entry (CDE) for the
device,
9109-096126-NA
Issue 1 Revision 0
126 14-13