Mitel SX-200 Practices page 1118

Peripheral Devices
SUPERSB4Uf Telephone Installation Instructions
10.4 installation includes unpacking the set, assembling the set and connecting the set to
a wall jack. The conneotions to the system via the cross connect field are described
in Practice 91 Og--O96-200-NA, Installation Information.
1 WARNING 1
Any connection of thls set to an off premlse appllcatlon, an out of plant applica-
'\
tion, or to any other exposed plant application may result In a safety hazard,
and/or defective operatlon, and/or equlpment damage.
Do NOT connect
SUPERSET
telephones In parallel, to standard lines, or as
power fall transfer extenslons. Do not use a hand test telephone (butt-in) to
check a
SUPERSET
telephone line (Its DNI Llne Card does not have a loop
detector). The set's on/off hook status Is signaled by data transmlsslon.
Before the set can be used, the system must be programmed and equipped with a DNI
Line Card to interface with a SU/?EFfSE~ 401 telephone. Refer to Practice
910%-096-210-NA, Customer Data Entry.
Chart IO-I
SlJPERSET407
Telephone Installation Instructions
Step
1.
Actlon
Connect the handset cord to the handset and the
SUPERSET
telephone.
2.
3.
4.
5.
Identify the set's number on the identification card.
install the identification card and protective cover onto the main assembly.
Connect the line cord to the telephone jack and the
SUPERSET
telephone.
The Message Lamp will blink rapidly for about
5
seconds and then go out. When
the lamp goes out, it indicates that communication to the PABX has been established.
Table 10-l
SUPERSET 401
Telephone Environmental Speclficatlons
Operating Environment:
Temperature:
Humidity:
Btorage/Shipping Environment:
Temperature:
Humidity:
0' to
35' C (32'
to 95' F).
0% to 90% RH, non-condensing.
-25'
to
70'
C (-13' to 158' Q.
0% to 90% RH, non-condensing.
126
10-8 Revision 0 9109-098-I 28-NA Issue 1