Mitel SX-200 Practices page 1083

m .
SUPERSET Description
Table 5-2 Installer Loop Test Routines
(continued)
Step
Action Verification Notes
Line Select Keys, HOLD Key, Line Status Dlsplay, and Tone Ringer Test
7.
Press the red HOLD key and each line The line status display next to each line
select key in turn.
select key (except HOLD) is activated
to indicate an incoming call (alternating
square/circle format).
;
A 2-digit number is displayed, as
follows:
HOLD key = 30
to
upper line select key = 45
The tone ringer sounds when the upper
line select key is pressed,
Hookswltch Test
a.
(a) If the tests are run with the handset "HANDSET UP" displayed.
on-hook, lift the handset.
(b) Press "speaker on/ofV key, and
Number 14 displayed, then "HANDSET
replace the handset.
DOWN" displayed.
9.
(a) If the tests are run with the handset "HANDSEr DOWN" displayed.
off-hook, press the "speaker on/off
key. Replace the handset.
(b) Lii handset.
"HANDSET UP" displayed.
Termlnatlng Test Routines
10.
If tests are run with the handset Set becomes idle; time and date are
on-hook, press the "speaker on/off displayed.
key; if tests are run with the handset
off-hook, replace the handset
Page 2 of 2
Notes: I. Access code is found in the CDE Form: Feature Accass Codes.
2. All prompts and line status displays are daarad.
3. Supplementary feature names are also displayed.
4. Do not press this key if tast is run in handsfree mode, as it will cause the test to be terminated.
5. If tast is run in handsfree mode.
6. Prompts remain displayed after key is released to allow error patterns to be detected.
7, Supplementary feature names remain displayed until another key is pressed.
9109-096126-NA Issue 1 Revision 0 126 5-13