Mitel SX-200 Practices page 1158

Peripheral Devices
Standalone DATASET 1103 Description
14.6 A Standalone DATASET 1103 is packaged in a flat case which can be placed under
a standard desk telephone. It is functionally the same as the DATASET 1101
Cartridge or one-half of the DATASET 1102 Dual Rack Mounted card (it shares the
same basic printed circuit board as the DATASET I 102 Dual Rack Mounted card).
The Standalone DATASET I 103 can be connected to the PABX using a four-wire
connection; two wires connect the dataset to the Digital Line Card, and two different
wires connect the telephone set Tip-Ring pair to an ONS or COV line card; it may
also be connected to a Digital Line Card within the PABX by a single twisted pair (the
telephone set is then connected independently). Figure 14-4 shows typical
,applications of a Standalone DATASET II 03 connected to a telephone set.and a
personal computer or terminal. The DATASET II 03 case is 206 mm wide x 270 mm
long x 35 mm high (8.1 in. x 10.6 in. x 1.4 in.).
Controls, Indicators, and Connectors
Its keys and LEDs are:
-AnN key
- DISC key
- POWER LED (includes SYNC to PABX information)
- READY LED (includes RxD traffic information)
- DEVICE (DTR) LED (includes TxD traffic information)
Standalone DATASET I 103 RJ-II modular connector pins are:
Line
Pin Signal
Typical modular
jack wire colors
1 no connection
2 data Tip
3 voice Tip
4 voice Ring
5 data Ring
6 no connection
black
red
green
yellow
Telephone
Pin Signal
Typical modular
jack wire colors
I no connection
2 no connection
3 voice Ring
4 voice Tip
5 no connection
6
no connection
green
red
126 14-6 Revision 0 9109-096-l 26-NA Issue 1