Mitel SX-200 Practices page 1148

Peripheral Devices
l
Press the SUPERKEY, This saves the pitch setting, stops the ringer and returns the
set to its normal state.
SUPERSET
430 Telephone Installation Instructions
13.4 installation includes unpacking the set, assembling the set and connecting the set to
a wall jack, The connections to the system via the cross connect field are described
in Practice 9109-09~200-NA, Installation Information.
piiq
- Any connection of this set to an off premise application, an out of plant a$plica-
tion, or to any other exposed plant application may result in a safety hazard,
and/or defective operation, and/or equipment damage.
Do NOT connect SUPEFfS~43Otelephones in parallel, to standard lines, or as Power
Fail Transfer extensions. Do not use a hand test telephone (butt in) to check
SWERSE~430 telephone lines; the Digital Line Card does not have a loop detector,
The set's on-/off-hook status is signaled using data transmission.
Before the set can be used, the system must be programmed and equipped with DNI
Line Cards to interface with a SUPERSET 430 telephone. Refer to Practice
9109-096-210-NA, Customer Data Entry.
Chati 13-I SUPERSET43OTelephone Installation Instructions
Step Action
1.
Connect the handset cord to the handset and the main assembly.
2. Wrfte the set's telephone number on the Brand/Extension Card.
3.
identify the set's extension number, other line appearances and features on the
Designation Card.
4. install the Brand/Extension Card, the Designation Card and the Feature Designation Card
and their protective lenses onto the main assembly.
5. Connect the line cord to the telephone and the telephone jack.
6. insert the line cord and the handset cord into the cord channels.
7. The Message Lamp and the Microphone Lamp will go solid red and the triangular line
appearance indicators will be on for about five seconds. When they go out and the LCD
displays the time and date, communication to the PABX has been established.
126 13-6 Revision 0 9109-096-I 26-NA issue 1