Table of Contents
Advertisement
Installing the 201i server in a large Meridian 1 system
Installing the NTRH3501 backplane cable
Introduction
You must connect the backplane (tip and ring) cable supplied with the 201i server (NTRH3501)
for 100Base-T Ethernet operation to the Avaya server subnet. This cable offers more network
throughput than the cable you just removed from the Meridian 1.
When installed, this cable completes the connection between the left slot, the I/O panel on the
rear of the switch, and the multi I/O cable on the 201i server.
Backplane (tip and ring) cable
The following diagram shows the NTRH3501 backplane (tip and ring) cable:
®
48
Avaya CallPilot
201i Server Hardware Installation
December 2010
Advertisement
Table of Contents
