The Cutting Results are Not Attractive
Is the Table Certainly Fixed?
The screw of the table may not be fixed firmly.
""Replacement the Table"
Is the Material Certainly Fixed?
There will be bad influence on the cutting result if the material is not firmly
attached to the table or scrap board. Increase the number of double-stick
tape and fix firmly.
""STEP 1 : Attach the Material to the Table"
Is the Cutting Tool Certainly Fixed?
Retighten the set screw of a collet and fix firmly.
""STEP 4 : Attach the Cutting Tool"
Is the Cutting Tool Tip Worn?
If the tip of the cutting tool is worn, replace with a new cutting tool.
""STEP 4 : Attach the Cutting Tool"
Is the Cutting Condition Optimal?
The optimal cutting parameters are determined by a balance of such factors
as the hardness of the material, the feed rate, the spindle rotating speed,
the cutting-in depth, and the capacity of the cutting tool. Refer to the
results and try fine tuning the parameters.
(p. 99)
(p. 70)
(p. 66)
(p. 66)
It Takes Time to Delete Data After Quitting Cutting
Depending on the state of the computer in use, deletion of processing data
may take time. Please delete by the following method.
Procedure
1.
[ Device and Printer ]
Click
menu.
2.
Double-click [ Roland SRM-20 ].
3.
[ Roland SRM-20 ]
dialog is displayed.
4.
In the
[ Roland SRM-20 ]
want to delete, click
[ Document ]
5.
If cutting data disappears from
the completion of deletion.
104
What to Do If...
[ Printer and FAX ]
( or
) from start
dialog, select the cutting data which you
- [ Cancel ].
[ Roland SRM-20 ]
dialog, it will be