What To Do If; Initialization Is Not Performed / Initialization Fails; Vpanel Does Not Recognize The Machine - Roland monoFab SRM-20 User Manual

What to Do If...

Initialization Is Not Performed / Initialization Fails

Is a Front Cover Open?
When starting the machine, make sure that the front cover is closed. For
safety, initialization is not performed when a cover remains open at startup.
Is a Front Guard Pull Down ?
When the front guard falls down, the front cover can not be closed firmly.
Therefore the machine is not performed.
"The Feature of this Machine"
"
Is a Large Amount of Cutting Waste Present?
Clean away any cutting waste. Clean the area around the spindle head
especially carefully.
""Cleaning the X-/Z-Shafts"
Is a Large Amount of Cutting Waste Present in the Dust Tray?
Clean away any cutting waste in the dust tray.
""Cleaning the X-/Z-Shafts"
Is Anything Caught on the Spindle Head or Rotary Axis Unit?
Check whether something has become caught and is impeding initialization.
(p. 8)
(p. 93)
(p. 93)

VPanel Does Not Recognize the Machine

Has Initialization Been Completed?
Has initialization been completed? Before you start VPanel, first switch on the
power to the machine.
(p. 11)
""Start VPanel"
Is the Computer Connected?
Check whether the connector cable has come loose. Please use the included
cable.
Is the Driver Installed Correctly?
If the connection to the computer is not made in the sequence described, the
driver may fail to be installed correctly. VPanel does not function normally
when driver is misconfigured. Check again to ensure that the connection was
made using the correct procedure.
" Download "http://startup.rolanddg.com"
""The Driver Cannot Be Installed"
100
(p. 105)